I was wondering if anyone has any ideas about the code and if they can see any glaring errors at all? Maybe the board isn't picking up revs correctly?Īnyway, here it is and thanks in advance. I get a response from the Arduino and can upload the code, but the shift lights don't seem to be coming on when I rev the car. Not shown on the diagram, but I'm using 1k ohm (I think) resistors with each LED. Description ShiftX3 adds an ultra-bright sequential shift light, twin alerts, and a 7 segment LED display for your RaceCapture system Features Ultra bright. The shift light sequential features four high power colour LEDs in. The circuit diagram is below, as is the code I'm using. The shift light sequential from Omex is based on the systems used in Formula 1 and BTCC. Each individual LED shift light can be easily programmed to illuminate for a specific engine speed value (rpm). It's the same sort of thing you see built into 2000 race dashboards and 50,000 Formula 1 steering wheels. They allow you to monitor your engine speed without having to take your eyes away from the road by lighting up a series of LEDs with engine speed. The project I'm working on is for a set of sequential shift lights for my car that come on one by one as the revs (rpm) rises. Stack sequential shift light models are designed to meet the demands of today's racing, as well as to assist with optimizing gear changes and protecting your engine from overrevving. We're big fans of sequential shift lights or LED tachs. Have been working through this for a while now and am still finding some issues, so I was hoping a post might be able to shed some light on the problems I've been having. This advanced microprocessor controlled sequential shift light unit is the ideal racing accessory for both the novice and experienced driver alike, not to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |